7 tips for dispensing pump disassembly:
1, detachable parts are not disassembled as far as possible without demolition. Dispensing pump in operation, use a small oil pan to take out the flow of diesel.
2, remove the pump rotor, the rotor must be distributed along the direction of rotation to be removed, use a special wrench when demolished.
3, the distribution of small screws in the middle of the right rotor pump center hole is the processing center stuffy stuffy hole, generally do not split.
4, the timing ring do not remove the cam ring, because it is fixed by its own flexibility in the body of the code, the factory positioning has been corrected, after the demolition is not easy to calibrate.
5, split spline sets and before and after the control panel, it should be noted that its original assembly location, so complex. Only adjust the maximum fuel supply before allowing a slight rotation around the control panel.
6, pressure regulating valve assembly, such as no failure, do not disassemble, if you must disassemble, you should pay attention to the pressure regulator valve spring do not lose, according to the original back.
7, in the dismantling triangle dish, you should hit a mark at the junction, so that when installed according to mark complex.
This article Keywords: pump
Vacuum Forming Machine,Foam Dish Machine,Foam Food Plate Machine,Foam Food Tray Machine
haiyuanmachinery , https://www.hyfoambox.com