The reporter learned yesterday from the Guangzhou Municipal Bureau of Quality and Technical Supervision that the General Administration of Quality Supervision, Inspection and Quarantine and the National Standardization Administration have recently approved the issuance of the GB20997-2007 Mandatory National Standard for Fuel Consumption Limits of Light Commercial Vehicles.
From February 1, next year, China's light commercial vehicles will begin to implement the national standard.
According to reports, this standard proposed by the National Development and Reform Commission is one of the supporting standards for the Energy Conservation Law.
It is understood that the standard sets fuel consumption limits for Phase I and Phase II of China's light commercial vehicles according to different fuels (gasoline or diesel), different maximum design total masses, and different engine displacements. From February 1, 2008, the newly certified basic vehicle and its variant vehicle shall meet the requirements of the second phase of the limit; as of January 1, 2009, the vehicle of the model is certified before February 1, 2008. The modified vehicle shall meet the requirements of the first phase of the limit; from January 1, 2012, all vehicles applicable to this standard shall meet the requirements of the second phase of the limit.
It is reported that China’s major manufacturers of light commercial vehicles learned about the degree of control of this standard as early as 2005 when the standard was first formulated. To avoid the blindness of two developments when developing new models, at the beginning of the development of standards, the The National Development and Reform Commission confirmed that the implementation of the new standard for newly certified basic vehicles should be completed in one step.
Industry sources pointed out that the first phase of the limit is relatively loose, the current domestic production of most of the light commercial vehicles can meet the limit requirements, the second phase of the limit on the basis of the first phase of the limit was tightened by 5% to 10%.
SRTA Silicone Rubber Fiberglass Heat-resistant Winding Belt
Description:
SRFA Silicon Heat-resisting glass fiber Winding Belt is made of non-alkali glass fiber braided fabric with thick iron oxide red silicone coating.
a) Can block molten iron splash effectively.
b) Can`t be damaged by high temperature and flame.
c) Fireproof, heat insulation, heat prevention.
d) Can work at 260 degrees high temperature environment continuously.
e) Can withstand 1090 degrees for 15~20 minutes.
f) Can work at 1650 degrees for 15~30 seconds.
g) Can protect the the worker from being burned by the high temperature pipeline.
h) Can save the cost of heat loss.
Application:
a) Widely used in soft hose, steam pipe, cables for high temperature protection.
b) Very suitable for wrapping the soft hose and cables.
Standard Size:
Part No. Width/mm Thickness/mm Length m/roll
SRTA-25 25 1.2 20
SRTA-50 50 2.0 20
SRTA-100 100 2.9 20
SRTA-150 150 3.5 20
SRTA-200 200 4.0 20
Product images:
Fire Tape,Fire Duct Tape,Fire Door Tape,Fire Detection Tape
KEYUACE Materials Co., Ltd. , https://www.insulationtubing.com