Seal installation method:
The installation method is different depending on the type of mechanical seal and the type of machine, but its installation methods are almost the same. The installation steps and precautions are as follows:
Before loading, the shaft (shaft sleeve) and gland must have no burrs, and the bearing condition is very good; the seals, shafts, seal chambers and glands are all cleaned. In order to reduce the frictional resistance, the part where the mechanical seal is installed on the shaft is to be thinly coated with oil so that it can be lubricated. However, considering the miscibility of the rubber O-ring, if it is not suitable to use oil, apply suds. . The structure of the floating static ring without anti-rotation pin is not suitable for oil coating and should be dry-loaded into the gland.
Determination of installation dimensions: In the installation, it is necessary to press the product's instructions or samples to ensure the installation size of the mechanical seal.
First, attach the stationary ring and the gland to the shaft. Be careful not to collide with the shaft. Then insert the moving ring assembly. The set screws of the spring seat or the drive seat should be evenly tightened several times.
The installation method is different depending on the type of mechanical seal and the type of machine, but its installation methods are almost the same. The installation steps and precautions are as follows:
Before loading, the shaft (shaft sleeve) and gland must have no burrs, and the bearing condition is very good; the seals, shafts, seal chambers and glands are all cleaned. In order to reduce the frictional resistance, the part where the mechanical seal is installed on the shaft is to be thinly coated with oil so that it can be lubricated. However, considering the miscibility of the rubber O-ring, if it is not suitable to use oil, apply suds. . The structure of the floating static ring without anti-rotation pin is not suitable for oil coating and should be dry-loaded into the gland.
Determination of installation dimensions: In the installation, it is necessary to press the product's instructions or samples to ensure the installation size of the mechanical seal.
First, attach the stationary ring and the gland to the shaft. Be careful not to collide with the shaft. Then insert the moving ring assembly. The set screws of the spring seat or the drive seat should be evenly tightened several times.
Nantong Weizhuo Environmental Protection Equipment Co.,Ltd , https://www.natongcwz.com